Airbar firmware update#
Airbar firmware software#
Airbar firmware download#

Multi finger support (up to ten fingers). The NTSMF 2.0-BETA1 has not yet passed the same endurance tests as Neonode zForceAIR 1.55ДЄvailable using the zForce Programmer tool Power consumption has been tested and the results shows a slightly higher current draw as compared to Neonode zForceAIR 1.55 Latency has been tested and the results shows that NTSMF 2.0-BETA1 is slightly slower Note however that the default configuration is always restored after flashing a new firmware.ДЄccuracy has been tested and the results compare well to those from Neonode zForceAIR 1.55 Using the zForce Programmer tool, the configuration can be changed permanently, and will then remain after a reboot. The Touch Sensor Module will always use the default configuration after reboot and after being re-flashed. This runtime configuration can not be saved to the Touch Sensor Module permanently.

Airbar firmware software#

Using the Neonode Workbench tool (or any other software that uses ASN.1 for configuration) the configuration can be changed in runtime. The Touch Sensor Module will always use the default configuration after reboot and after flashing a new firmware. Supports the 90-degree version of the Neonode Touch Sensor Module, but not fully tested. Supports the 90-degree version of the Neonode Touch Sensor Module. 346 (with option to enable Extended Range).310 (with option to enable Extended Range).295 (with option to enable Extended Range).For different variants availability and a Firmware version, please, refer to Mechanical Data.В Extended Range can affect the power consumption and the accuracy. These come in two variants: with a default TAA length (in the Y-axis), so called non-extended range and with an extended TAA length (in the Y-axis), extendedВ range. Touch Sensor Modules with A в‰Ґ 237.6 mm are long enough to use a scanning pattern that extends the active area in the Y-direction. Extended RangeДifferent Touch Sensor Module types vary in physical length and thus also in the Touch Active Area dimensions in the X- and the Y-axis. This is mostly used for legacy systems or systems that do not have support for HID Touch Digitizer.

The Absolute Mouse firmware version will make the operating system recognize the sensor as an absolute mouse device instead of a HID Touch Device. For more information or if you have any questions, please contact Neonode Support. These versions are only to be used for evaluation purposes and should not be used in a live or production environment.

The evaluation firmware release versions 1.53 and 1.55 each comes in two variants : an Absolute MouseВ version and an Extended Range version.

Airbar firmware update#

Touch Sensor Module - Firmware Update 1.55 Extended Range 374, 346, 310, 295 mm Touch Sensor Module - Firmware Update 1.53 Extended Range 374, 346, 310, 295 mm Touch Sensor Module - Firmware Update 1.55 Absolute Mouse 346mm

Airbar firmware download#

Touch Sensor Module - Firmware Update 1.55Д®valuation Download Touch Sensor Module - Firmware Update 1.53 Absolute Mouse 346mm Releases Touch Sensor Module - Firmware Update 1.53 ZForce Programmer can be found here: zForce Programmer Downloads. Neonode Touch Sensor Module Firmware 2.0-BETA1 should not be installed with the previously used Update Firmware tool, but rather the new zForce Programmer tool. Beta Releases Neonode Touch Sensor Module Firmware 2.0-BETA1